Mikov V2003015 Unhandled Dual Bevel Marking Knife Kit with Knife Finger Indents 0.100 Inch Thick Blade 1/2 Inch Wide 5-7/8 Inch Long Stainless Ste...

Mikov V2003015 Unhandled Dual Bevel Marking Knife Kit with Knife Finger Indents 0.100 Inch Thick Blade 1/2 Inch Wide 5-7/8 Inch Long Stainless Steel Hardened to HRC 57
This unhandled Dual Bevel Spear Point marking knife kit was made to our specifications by Mikov a world-class Czech knife maker. Mikov is currently the largest knife maker in the Czech Republic and has been making knives since 1794. maker. Mikov is currently the largest knife maker in the Czech Republic and has been making knives since 1794.
The blade is made from AISI 420 corrosion resistant stainless steel and hardened and tempered to HRC 57. This is the same steel used in many of Mikov’s kitchen knives and is designed to take and hold a keen edge and resist corrosion.
The blade is 5-7/8 inches long, 1/2 inch wide and 0.100 inch thick. The blade has a dual-bevel spear point tip. The tip is ground to 55 degrees with a 25-degree angle grind on both bevels. The bevels are precision ground on CNC machines. The laser cut finger indents are useful for applying pressure closer to the tip.
The dual bevel will mark distinct lines equally well on both the right and left side of a part or guide. It will leave crisp lines marking with and against the grain and on end grain. The knife may require just a light stropping to remove a small wire edge to get it razor sharp and ready to use.
The knife can be used either unhandled or wood scales can be attached to make a handle. If a handle is desired the kit comes with 2 brass pins to affix the scales to the blade.



7 x 1 x 1 inches

Return

Payment

Feedback

Contact Us